Can you clean a grease trap yourself?
For a thorough cleaning, utilize the shop vacuum to suck out any lingering FOGs from the grease trap. Next, refresh the grease trap and free the tank from obnoxious odors with a little elbow grease, a steel pot scrubber, dish soap and tepid water. Thoroughly scrub down the grease trap’s baffles, sides and lid.
How often should a grease trap be pumped out?
every one to three months
A good rule of thumb for any cleaning schedule is every one to three months. However, in order to determine if it should be one or three, you will need to follow the 1/4th rule. This rule states that once 1/4th of your grease trap has been filled with fats, oils, grease, and solids (FOGS) it is time for a pump out.
How much is an above ground grease trap?
On average, a small grease trap installation costs between $250 and $1500.
How do you clean an outside grease trap?
Scoop out the grease – After placing a garbage bag into a trash can, dip the catch basin scoop down into the grease trap so the top of the scoop just barely breaks the surface of the water. Slowly pull the scoop up to capture grease and allow the water to drain through the holes on the bottom and sides of the scoop.
How do you clean a restaurant grease trap?
With most of the grease removed, it’s time to give the trap a shine. Use soap, warm water, and a steel pot scrubber to clean the lids, sides, baffles, and other parts of the trap. Doing this will also eliminate bad odor from the trap. Flush the trap with clean water to remove soap and debris.
How do you clean a commercial grease trap?
Scrape down the lid and the sides of the trap with your bucket. Remove any large pieces of fat or oils that are attached to the trap. To achieve an even cleaner trap, you can use a wet/dry vacuum to suck out any smaller bits of waste. Clean the lids, trap sides, and parts with soap and room-temperature water.
How do you remove a grease trap?
Remove the water from your grease trap, either with a bucket or a small pump. Set this water aside. Start scooping out the grease from your trap. You can use another bucket, a shovel or other heavy duty scooper. Scrape the bottom, sides and lid to remove any excess grease.
What is a commercial grease trap?
Commercial Grease Traps & Interceptors. A. A grease trap works by slowing down the flow of warm/hot greasy water and allowing it to cool. As the water cools, the grease and oil separate and float to the top of the grease trap. The cooler water (less grease) continues to flow down the pipe to the sewer.