How do I reset my Maytag Neptune washer?
Turn off and unplug the washer. Wait 30 seconds. Reconnect it and press the “Power” button. This resets the unit.
Where is the reset button on Maytag Neptune washer?
How to Reset the Sequence for a Maytag MAH5500BWW
- Locate the “Off” button, located to the right of the Neptune’s “Start/Pause” button.
- Press the “Off” button within the first 30-seconds of beginning the cycle to cancel the current cycle.
What causes a Maytag washer to stop working?
Common solutions for: Maytag Washer stops mid cycle If the washer door is not latched shut, the door switch prevents the washer from operating. If the door lock is defective, the washer may stop mid cycle. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
Why would my washing machine just stopped working?
There are a number of possible causes for your washing machine not working as it should. Some of the most common faults that will make your washer stop mid cycle include thermostat failure, problems filling up with water for the rinse cycle, or even pump problems that prevent your washer from draining.
How do you run a diagnostic test on a Maytag Neptune washer?
I checked the diagnostic code using the following procedure:
- Plug the washer in for power.
- Put the washer into “Service Mode” by holding the “Delicates” and “Heavy soil” keys simultaneously for 3 or more seconds.
- Pushed “Presoak” to put it in diagnostic code mode.
Where are the fuses on a Maytag Neptune washer?
Maytag washers have a fuse in the lid-switch assembly. Maytag top-loading washers have a fuse in the lid-switch assembly. When you close the lid after adding the laundry and soap, the lid’s plastic switch contacts with the assembly underneath.
How do you put a Maytag Neptune washer in diagnostic mode?
How do I reset my Maytag front load washer?
You also can reset the washer if you want to cancel a setting you chose.
- Press the “Power/Cancel” button. Video of the Day.
- Push the appropriate button to choose a new cycle.
- Press “Start/Pause.” You have now reset your Maytag washer. resources. CNET: Washer Buying Guide. Chad Buleen. PEOPLE ARE READING.
Do Maytag washers have a reset button?
Press and hold the Start/Pause button for 3 seconds. All indicator lights should be off at this point. Reset the Washer: To reset (clear) the washer, rotate the Cycle Selector Knob counter-clockwise (left) to clear any sequence.
Is there a reset button on a Maytag washing machine?
Why is my washing machine on but not starting?
The first thing to do when diagnosing a problem with your washing machine not starting a cycle is to check to see if the fault is with the wall socket, rather than the appliance itself. The next thing you should check is the machine’s fuse. Try replacing the fuse with one of the same amps.
How do you clean a Maytag Neptune washer?
Use high-efficiency detergent in your Neptune washing machine to keep your washer fresh-smelling and free of buildup. Turn off the washing machine, and remove any laundry from inside of it. Examine the gray-colored seal located inside the open washing machine door.
How to reset Maytag washer?
Unplug the washer for 1 minute from the electrical outlet.
What are some common problems with Maytag washers?
The three most common problems with Maytag washers are a washing machine that does not start, a unit that does not spin and the washer not draining water. The specific problems with Maytag washers depend on the particular model.
What caused the Maytag Neptune recall?
The Maytag Neptune front-load washing machine recall was caused by water leakage, resulting in electrical problems, issues with mold and improper function.