What is the plate behind a door knob called?
Trim
Trim: Sometimes called a rose, the trim is a decorative plate attached to the door under the knob or lever.
What is a Cabinet pull backplate?
Cabinet hardware backplates are installed against a cabinet door or drawer front. They are placed before a knob or pull is installed and have predrilled holes for the screw to go through. When the screw is tightened into the knob or pull, the backplate is also held in place.
What is a backplate on a lock?
BACKPLATE A stamped or forged plate onto which levers and knobs are attached to create the door handle. BACKSET A lock or latch measurement which determines the distance of the centre of the Follower (Spindle Hole), and therefore of your handle / knob, from the edge of the door.
What is a backset on a door?
The backset is the distance from the edge of the door to the center of the 2-1/8-inch bore hole. In the United States, there are two common backsets for residential door locks: 2 3/8 inches and 2 3/4 inches.
What is a strike plate?
Strike Plate This is the plate the latch-tongue, or deadbolt-tongue will connect with. It should sit flush with the door jamb. Any passage or privacy set needs to have a strike plate for the door to latch. Additionally, deadbolts need a strike plate to properly lock.
What is a mortise plate?
A mortise refers to the pocket cut into the door where the lock is fitted. Strike plate–the metal plate affixed to the door jamb with a hole for the bolt of the lock to slide into, keeping the door closed. A skeleton key to operate the locking and unlocking functions of the lock body.
What are cabinet plates?
Another genre of Royal Vienna porcelain dating from the turn of the century is that of decorative plates, often called ‘cabinet plates’. The term refers to the fact that the plates of this type were intended purely as decorative items – literally, displayed in a cabinet – rather than coming into contact with food.
How do you install back cabinet panels?
By far the easiest method is just to staple or nail the panel onto the back of the cabinet. Just cut a piece of ¼” plywood large enough to cover the edges of the box and tack it into place every 8-10 inches. If you integrated the toe kick into the sides, the back panel can extend all the way to the floor.
What is a Lockcase?
Lock cases is the unit that keeps the door closed. A lock case consists several parts, but two of them especially affect the lock unit classification as an approved lock. It is the dead bolt (fallkolv) and the bolt (regel).
What is a follower on a door latch?
Quite simply, the term ‘Follower’ refers to the hole in a mortice latch or lock where the spindle* passes through the latch or lock body and the door. A follower is found on all Latches and Locks that have latching capability.
How do you measure a door backset?
The backset is the measurement from the edge of the door to the center of the bore hole. Most door handle sets feature a 2-3/8″ or 2-3/4″ backset. To determine the backset on your door, measure the distance from the outer edge of the door, to the center, or highest point of the bore hole.