What is EC mode on hot tub?
Ecn or Ec Message Ecn or Ec is Alternating with Temp: The Spa is Operating in the “Economy” (Ecn or Ec) Heating Mode. The Water Temperature is sampled Only during Programmed Filter Cycles. The Heater will only operate and Heat up to Set Temperature during the Filter Cycles.
How many gallons does a Leisure Bay hot tub hold?
Seats: 3 Adults. Dimensions: 60″ x 83″ x 33.5” H. Water Capacity: 225 Gallons.
How do I reset my leisure Bay Spa?
Remove the spa hot tub hard cover and allow water to cool off. Once the spa cools down to 107°F, the tub should reset on its own. If the hot tub does not reset, turn off the power to the spa and call your dealer or service company. No action is required at this time.
How do I turn on Leisure Bay spa?
Turn on power to spa at the circuit breaker box. The heater and pump 1 (low speed) will automatically activate. Depress JETS 1 topside pad on the control panel once to activate pump #1 in high speed and initiate maximum water flow to certain jets.
What mode should my hot tub be?
Economy is a good setting for those who use the hot tub daily. The drop in temperature fluctuates during the year from minor or no temperature falls in the summer, to larger drops in the coldest part of winter.
How much shock should I put in my hot tub?
Measure 17g of non-chlorine shock per 1500 litres or 35g of chlorine shock per 1500 litres (consult the label instructions as this can vary based on chemical quality and brand). Carefully add the required shock to the hot tub. Leave the cover off for approximately 20 minutes.
What is the average size of a 6 person hot tub?
A 6-8-person hot tub’s average size will generally be 80-90 square feet, with varying dimensions. For a hot tub of this size, you can expect to need as much as 600 gallons of water to fill the unit.
Where is the reset button on my hot tub?
Locate the spa’s high-limit reset. This is a red button found on many spa packs. It may be located on the heater and covered by a rubber nipple.
Do hot tub pumps have a reset button?
There are generally two “hard resets” in hot tubs, the GFCI, and the high limit reset. The GFCI pops if there is any type of electrical short (such as water getting into the heating element, the reset on that can be in one of three places.
Why has my hot tub stopped working?
It could mean a worn breaker, too much moisture at the breaker box, corroded electrical components, or damaged and loose wiring. It is best to contact a hot tub pro to help you properly fix these issues.
What does F8 mean on a hot tub?
Filtration Cycles run from F1 to F8 (F1 = 1 hour every 12 hours / F8 = 8 hours every 12 hours). Preset cycle set from factory is F1, so if in ec or sl mode your water will not reach desired temperature.