How do you reset a port on a Brocade switch?

How do you reset a port on a Brocade switch?

Resetting the Brocade FC switch to factory defaults

1. Log in to the switch as an administrator.
2. Disable the Brocade Virtual Fabrics (VF) feature:
3. Disconnect the ISL cables from the ports on the switch.
4. Disable the switch:
5. Disable the configuration:
6. Clear the configuration:
7. Save the configuration:

How do I enable Zoning Brocade?

Creating zones in a Brocade FC switch

1. Record WWPN. Members of a zone are identified by their World Wide Port Numbers(WWPN).
2. Check Config.
3. Create Aliases.
4. Create Zone.
5. Add zone to config.
6. Save config.
7. Verify config.
8. Enable config.

How do I enable root account in Brocade?

Article Content

1. Login via admin.
2. Check the root access: #rootaccess –show. RootAccess : none. (when the root access isn’t allowed it would return output “none”)
3. To allow the root access:

How do I remove configuration from my Brocade switch?

How to remove a brocade switch from Fabric

1. Disable/Remove the ISLs to the switch which you want to remove.
2. disconnect/migrate the cable to new switch.
3. disable the switch and clear the configuration.

How do I get to the ruckus GUI?

To log in to the Web Management Interface, perform the following steps.

1. Open a web browser and enter the IP address of the management port in the Location or Address field.
2. Click Login.
3. Enter the user name and password that you created using the CLI as described in Prerequisite configuration.

What is Brocade network Advisor?

BrocadeNetwork Advisor simplifies storage network management and helps administrators proactively diagnose and resolve issues to maximize uptime, increase operational efficiency, and reduce costs. This wizard-driven interface from Brocade, A Broadcom Inc.

How do you configure zoning on a Brocade switch using the command line?

How to create zones from CLI on a Brocade SAN Switch

1. admin> switchshow.
2. Note:Any devices that connect using NPIV use nsshow command to find the WWPN addresses logged in to the port.
3. 2.Run the cfgshowcommand.
4. admin> cfgshow.
5. cfgshow will display the configuration and how the zoning is currently configured.

What is SAN zoning?

SAN zoning is a method of arranging Fibre Channel devices into logical groups over the physical configuration of the fabric. SAN zoning may be utilized to implement compartmentalization of data for security purposes. Each device in a SAN may be placed into multiple zones.