Which of the following is an alternative fall protection option for low slope roofing work?
safety monitoring system
A safety monitoring system is an alternative fall protection option for low-slope roofing work; this requires the designation of a competent person to monitor the safety of workers and to warn them when their work puts them close to a fall hazard.
Can you work on a roof without fall protection?
No, there isn’t. As far as OSHA is concerned, there is no safe distance from the edge of a roof, so you must be protected. This means that you must have rails, fall arrest systems, or a warning line/safety monitor setup no matter where it is you are working.
When working on roofs what is required?
In general, OSHA’s fall protection standard, §1926.501, requires that each employee on a walking/working surface (horizontal and vertical surface) with an unprotected side or edge which is 6 feet (1.8 m) or more above a lower level shall be protected from falling by the use of guardrail systems, safety net systems, or …
What does OSHA consider a low-slope roof?
OSHA defines a low-slope roof as a roof having a slope of less than or equal to 4 inches of vertical rise for every 12 inches horizontal length (4:12) (1926.500(b)—definitions).
What is considered a low-slope roof?
A low-slope roof is one that has a slope of less than 3-in-12. This means that for every horizontal foot, the roof level goes up less than 3 inches vertically.
What does OSHA consider a low slope roof?
Can you work on a roof without edge protection?
You must also fit edge protection to the eaves of any roof and on terraced properties to the rear as well as the front. Where work is of short duration (tasks measured in minutes), properly secured ladders to access the roof and proper roof ladders may be used.
How close to the edge of a roof can you work?
6 feet
OSHA 1910 Walking-Working Surfaces Standard Requirements For general industry working at a 4-foot height, or a low sloped roof, OSHA requires: 6 feet from the edge: conventional fall protection (guardrail, fall restraint or fall arrest system) is required.
What is a low sloped roof OSHA?
OSHA Low Slope roof and Walking Working Surfaces Standard – Low Sloped Roof Fall Protection Defined “Low-Sloped Roof” is a term that OSHA felt it needed to be defined in its Walking Working Surfaces update published November 18, 2016. A low-sloped roof is defined as a slope equal or less than a ratio of 4 to 12.
How big of a roof can a safety monitoring system be used?
Or, on roofs 50-feet (15.25 m) or less in width (see Appendix A to subpart M of this part), the use of a safety monitoring system alone [i.e. without the warning line system] is permitted. “Steep roofs.”
What does a red line mean on a roofing safety assessment?
Detail from roofing safety assessment. Red indicates a warning line, drains within six feet of the roof’s edge, or ladders that need guardrails. OSHA has designated three work zones on low-slope roofs with unprotected edges that are four feet or more above a lower level:
How high should a roof fall protection system line be?
Instead, it should be a line that is 39 to 42 inches high. Typically, lines are yellow so it’s clear to those on the roof that they’re not supposed to cross that line without OSHA-required restraints. OSHA still recommends conventional fall protection systems within the high danger zone.