What battery for a Kawasaki Mule 4010?
Zipp Battery YTX20L-BS (20L-BS 12 Volt,18 Ah, 270 CCA) Utility Vehicle Battery for Kawasaki Kaf620f, Mule 4010 4×4 620cc 09.
What size battery does a Kawasaki Mule take?
What size battery does the Kawasaki Mule need? For this particular workhorse, you’ll need to start with a 12V battery (that much should be blindingly obvious) with about 200 cold cranking amps.
How long does a Kawasaki Mule battery last?
With adequate care and maintenance, the battery can potentially last for as much as six years.
Where is the battery on Kawasaki mule?
Begin by turning the vehicle off. Locate and remove the battery compartment cover on the passenger side, behind the rear bench (Figure 1).
How many amps is a Kawasaki Mule battery?
Capacity: 18 Amp Hour. CCA: 250. Height (w/terminal): 6.14″ Length: 6.89″
How do I know if my ATV battery is bad?
How do I know if my ATV battery is bad? If your battery is reading 0 volts, chances are the battery experienced a short circuit. If the battery cannot reach higher than 10.5 volts when being charged, then the battery has a dead cell.
How long do you charge a 4 wheeler battery?
If you have a smart battery charger, it will stop charging automatically as soon as the battery is fully charged. Usually, this should take no more than 12-16 hours unless the battery was completely flat….How long should you charge an ATV battery?
| State of charge | Charge time |
|---|---|
| 50% | 6 – 10 hours |
| 25% | 10 – 14 hours |
What volt battery is in a Kawasaki Mule?
12 Volts
Enhance your purchase
| Brand | Mighty Max Battery |
|---|---|
| Vehicle Service Type | Personal Watercraft |
| Voltage | 12 Volts |
| Battery Cell Composition | Sealed Lead Acid |
| Item Weight | 1 Pounds |
What amp should I charge my ATV battery at?
For all ATV and UTV batteries The charger should be 12V (as long as your battery is 12V). The charger should be able to provide a low amp charge rate, typically 1-3A.