What is the best wood to use for a patio cover?
For most patio covers, Ming recommends Douglas fir, which can be ordered smooth or rough-sawn. Fir needs to be painted or stained to match the wood trim on the house, he said, but is considerably less expensive than redwood or cedar.
How far apart should posts be for a patio cover?
Common Post Spacing In general, the maximum span for a 4-by-6 beam is 6 feet between 4-by-4 posts. If you move up to 4-by-8, you’re usually allowed to span up to 10 feet between posts. A 4-by-10 can usually span up to 12 feet between posts.
What is the average cost of a patio cover?
How much does a patio cover cost? The average cost of a patio cover or awning installation project is $500, and the average cost range is $380-$700. On the low end, prices range from $91-$200; on the high end, they range from $3,000-$10,149.
Should I use pressure treated wood for covered patio?
Pressure-treated pine, the most affordable option, is rot and insect resistant. However, a preservative will need to be applied after construction to slow the process of weathering. Pressure-treated pine can be stained nearly any color you like. Another type of wood that can be used to build a patio cover is cedar.
How do you attach a ledger board to a house for a patio cover?
Attach the ledger with 1/2-inch-diameter lag screws or bolts every 16 inches (or as specified by local building codes). Slip stainless-steel washers between the ledger and the siding to allow water to flow behind the ledger. If you can’t get behind the joist to cinch down nuts, use lag screws.
Can I use 4×4 post for patio cover?
The smallest beams for patio covers are typically 4-by-6. In general, the maximum span for a 4-by-6 beam is 6 feet between 4-by-4 posts. If you move up to 4-by-8, you’re usually allowed to span up to 10 feet between posts. A 4-by-10 can usually span up to 12 feet between posts.
How do you build a covered patio?
Instructions. Fill the holes at the base of the patio cover with stones, and secure that it is tightly packed. This should give added support to the weight of the roof. Then you will create a support beam at the top of the posts by using 2*12 boards and setting it into the roofline then screw the corners together.
How to build a patio cover?
Choose your Type of Patio Cover – Solid,Lattice,or Combination; Insulated Roof Panels
How to cover a patio?
Top With an Enclosed Skylight. This enclosed patio designed by Tamsin Johnson feels like a cross between a chic living room and a jungle-inspired greenhouse.
How to get a patio cover building permit?
A permit is usually easy to obtain from your local building department, however verify that your local building dept. does accept the engineering before you purchase a Patio Cover from us. Contact your local Building Department or governing agency and ask: