How do I program my ultra start remote starter?
Turn the ignition key to the On position. 2. Press and hold the Program Button (Located on the antenna) for 5 seconds or until the horn (optional) honks two times. NOTE: The LEDs on the Antenna will turn off and the remote starter functions will be re-enabled.
How do I reset my autostart remote starter?
Press the Lock button on your remote car starter. Within five seconds of turning it on, turn your key back to the “off” position (or press the start button again). Repeat the on-off cycle three more times—you’ll do four in total.
Why is my remote car starter not working?
Cause: It is rare, but does happen – in most cases, this is caused by a dead battery in the vehicle or the battery having been disconnected when being serviced. Remote starters usually have some type of non-volatile memory to retain things like programming features and remote control codes.
Why is my remote start blinking blue?
The blue LED light will flash when the vehicle is locked/armed.
How do you start a car with the remote start button?
Grab all of your car’s remote-start fobs. While in the driver’s seat, close the driver’s side door. Insert your ignition key and turn it to Accessory (or press the start button once without pushing the brake pedal). Press the Lock button on your remote car starter.
What is autocommand® remote car starter?
The AutoCommand Remote Car Starter system allows you to start the car by remote control from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter. AutoCommand®is for automatic transmission cars only. It is an extremely sophisticated system with multiple built-in safety and security features.
What is a remote engine starter system?
The remote engine starter system consists of a transmitter that allows you to start and stop the engine from outside the vehicle. Some communities may have restrictions on the use of remote engine starters. Before using your remote engine starter system, please check all local laws and regulations.
How do you hook up a remote starter to a tachometer?
Locate and connect the tachometer wire to the tachometer output wire on the remote sensor. This is required by the remote starter so that it disengages the starter once the car has started. It can usually be found in the engine distributor or coil pack.